Lucent Technologies 518-458-100 manual Problems with Manual Backup

Models: 518-458-100

1 407
Download 407 pages 55.58 Kb
Page 357
Image 357

Troubleshooting

Problems with Manual Backup

Display Shows “Insert Card” in

System Programming Mode

Possible Cause: The system did not detect a valid Backup/Restore PC Card when you tried to do a manual backup using Backup Programming—Manual (#124) .

NOTE:

If an ASA/DXD or PARTNER Voice Mail PC card is in use, perform Backup Programming—Manual (#124) as described in Chapter 5. Deactivate automatic backup to prevent this from reoccurring.

What to do: Power down the system, insert a valid Backup/Restore PC Card in the PC Card Slot of the PARTNER Endeavor processor module, and reapply power to the system. Restart the procedure.

Display Shows “Write Protected” in

System Programming Mode

Possible Cause: You tried to do a manual backup using Backup Programming— Manual (#124), but the Backup/Restore PC Card in the PC Card slot is write-protected.

What to do: Using the end of a paper clip or another pointed object, gently push the write-protect tab upward to the non-protected position (see Figure 6-7), and try the procedure again. (You do not need to remove the card from the processor to slide the write-protect tab up.)

ECS

PROC.

Slide the switch on the PC card up to the nonprotected position

Figure 6-7. Write-Protect Tab on a Backup/Restore PC Card

6-26

Page 357
Image 357
Lucent Technologies 518-458-100 manual Problems with Manual Backup, Display Shows Insert Card System Programming Mode