Lucent Technologies 518-458-100 manual Programming, 146

Feature Reference

■To respond to a signal, the target extension must place an intercom call to the person signaling.

Programming

(See Figure 2-2on page 2-19for the location of special programming buttons such as sand eon system phones.)

To program a Manual Signaling button:

1.Press f00sscat extension 10 or 11.

2.Enter the number of the extension to be programmed with this feature.

3.Press a programmable button.

4.Press f13.

5.Dial the two-digit extension number of the target extension. For example, to identify extension 22 as the target extension, press 22. (Enter *before the extension number if you want to use the button for voice signaling.)

6.Program another button for this extension or exit programming mode.

Using

To beep the target extension:

1.While the handset is in the cradle, press the programmed button. The extension beeps for as long as the button is pressed.

To ring or voice signal the target extension:

1.Lift the handset or press S.

2.Press i.

3.Press the programmed button.

To transfer a call to the target extension:

1.While active on the call, press &.

2.Press the programmed button.

5-146