10
Creating a new Style
You can assign the following Tones to each style part.
Drums (ADrum): rhythm sets
Bass (ABass): tones other than rhythm sets
Accompaniment (Acc 1–6): any tone
6. Press [ ] to start recording.
If the Count In setting is WAIT NOTE, recording will start
the moment you play a key.
7. Play the keyboard.
8. Press [ ] to stop recording.
If you want to keep the recorded style, save it as
described in “Saving the Style you recorded” (p. 12).
1. If you want to create a new Style from scratch, initialize
(p. 9) the Style and then proceed to step 4.
If you want to record using an existing Style, select the
desired Style (p. 25 in the owner’s manual).
2. Press [MENU] so the button is lit.
3. Use [ ] [ ] to select “Style Composer,” and press
[ENTER].
The STYLE COMPOSER screen will appear.
4. Use [ ] [ ] [ ] [ ] to select the division that you
want to record, and press [SONG REC].
The Style Rec Standby screen will appear, and [SONG
REC] will blink.
5. Press [SONG REC] to change REC TYPE to “STEP REC.”
By pressing [SONG REC] you can switch between REALTIME
and STEP REC.
You can also switch between REALTIME and STEP REC by
moving the cursor to REC TYPE and turning the VALUE dial.
6. Use [ ] [ ] [ ] [ ] to select a parameter, and
turn the VALUE dial to change the value.
Rec Mode
REPLACE New material is recorded as
previously recorded material
is erased.
MIX New notes are recorded on
top of notes previously
recorded.
Count In
OFF
No count-in. Recording starts
as soon as you press
[].
1MEAS Recording starts after a 1-bar
count-in.
2MEAS Recording starts after a 2-bar
count-in.
WAIT NOTE
Recording starts as soon as
you play a note on the
keyboard. (There will be no
count-in.)
Input
Quantize
OFF, 1/4,
1/8, 1/8T,
1/16,
1/16T,
1/32,
1/32T,
1/64
Quantize corrects the timing
of your notes by shifting them
to the nearest grid mark. This
specifies the number of steps
per measure (i.e., the
resolution).
Key C–B Specifies the key to record.
Octave -4–+4 Adjusts the notes during
recording, in octave steps.
Length Off, 0001– Specifies the number of
measures to record.
Parameter Value Explanation Step recording
Parameter Value Explanation
PART
ADrum,
ABass,
Acc1–6 Selects the part to record.
TONE Selects the tone.
Prelude_OM_Ver2.book Page 10 Wednesday, September 9, 2009 5:38 PM