Roland COLORCHOICE The Setup Properties Cut Tab (CAMM JET/ColorCAMM)

This intent is was created to supplement the Saturation intent. Spot Color maps colors similarly to

the Saturation rendering intent, but Spot Color rendering intent produces the greatest saturation

possible, and should not be used with photographic images .

If your output device supports multiple color modes, th en you can select one of the supported color modes

here.

The Setup Properties Cut Tab (CAMM JET/ColorCAMM)

The Cut tab displays cut settings.

Changing this value from the default is not recomm ended.

Specify how many times the blade will move over each line.

Select how smooth you would like the curves to be.

Clicking this button launches the Cutter Driver Options d ialog box, shown below.

Custom Head Tab

None

When this mode is selected, Roland COLORCHOICE will not sen d any settings regarding the cutting

operation. The settings in the printer panel will be used inst ead.

Cut Fast, Cut Medium, Cut Slow

When these options are selected, Roland COLORCHOICE will send the settings for the cutting operation.

These settings will only take effect if the "VS COMMAND" a nd the "!FS COMMAND" are set to

"ENABLED" in the Printer panel. Each item can be unc hecked to use the setting in the Printer panel.

Offset

Set the appropriate value for the blade in use. Inappropr iate values in this field can lead to poor cut

quality or unfinished cut lines. The default value is 250 (0.25mm).

Speed

Set the cutting speed. Usually setting a lower speed will res ult in longer cut times, but will produce higher

quality results.

Force

Set the blade pressure for cutting. When the values set her e are too small, the blade will not have

enough pressure to cut the sheet. Similarly, if the pressur e is too high, not only it will not work properly,

but it can cut through the back of the media and may cause dam age to printer. Be careful to set the

correct value for the thickness and the hardness of the m aterial you are using.

Custom End tab

Use this tab to specify that the media be cut after the job f inishes. Selecting Cut Media and also

checking the Cut Media checkbox will send the appropriate cutti ng instruction to the cutter. Selecting

None prevents the media from being cut.