![](/images/new-backgrounds/1255859/25585919x1.webp)
Panel Descriptions
Rear Panel
[ATT] knob
This adjusts the final output level of the headphones.
Normally, you should use the top panel PHONES [VOLUME] knob to adjust the headphone output level.
Use the [ATT] knob to adjust the output level appropriately for the sensitivity of the headphones you’re using.
☞“Adjusting the Headphones Output Level” (p. 29)
PHONES jacks 1, 2
Connect headphones to these jacks.
•Jack 1: stereo mini type
•Jack 2: stereo phone type
The headphones you connect must have a minimum impedance of 16 ohms.
*If headphones are connected to both jack 1 and jack 2, make sure that the total impedance of the headphones is not less than 16 ohms.
LINE OUT L/R jacks
These are TRS type (balanced) line output jacks.
*The
LINE OUT REC L/R jack
This is a stereo mini jack that outputs a line out signal.
Use a stereo mini plug cable to connect this to a device such as one from the EDIROL
AMBIENT MIC
This is a
☞“Using the
AUX IN L/R jack
This is a stereo mini jack that inputs an audio signal.
Use a stereo mini plug cable to connect this to one of the devices in the BOSS Dr. Rhythm series or the EDIROL
[DIMMER] switch
This switches the brightness of the indicators.
ON | Darker. |
|
|
OFF | Brighter. |
|
|
REAC port (supports REAC EMBEDDED POWER)
Connect a REAC cable to this port.
This port can input up to 40 channels of digital audio signals being output from the master REAC device.
* The
About the power supply
The
10