107
Chapter 7. Connecting External Devices
■
When connecting a MIDI sequencer, set Local Control to
“OFF.” The setting is at “Local Control ON” when the RG-
3M is powered up.
As illustrated, information describing what has been played
on the keyboard is passed to the sound module over two
different routes, (1) and (2).
As a result, you hear overlapping or intermittent sounds.
To prevent this from happening, route (1) must be disabled,
by setting the unit to what is known as “Local Off.”
fig.07-130
Local On:
The keyboard and internal sound generator are
connected.
fig.07-140
Local Off:
The keyboard and internal sound generator are
separated. No sound will be produced by the keyboard
when it is played.
fig.07-150
→
When connecting a unit in the Roland MT series, you don’t
need to switch off Local Control. MT units transmit Local Off
messages when their power is switched on. If you first switch
on the RG-3M, then the MT-series device, Local Control is
automatically switched off on the RG-3M.
1.
Press the [Function] (Exit) button, getting its
indicator to light.
2.
Press the [Song] (Select -) button or [ ] (Select
+) button to display the MIDI screen.
fig.07-110d
3.
Press the [Song] (Select -) button or [ ] (Select
+) button to get the value for “Local” (Local
Control) to flash.
fig.07-151d
4.
Press the [ ] (Value -) button or [ ] (Value
+) button to switch Local Control on or off.
5.
Press the [Function] (Exit) button so the indicator
goes out.
(1)
MIDI
MIDI
MIDI
MIDI
(2)
IN
IN OUT
OUT
Sequencer
Memory
Sound
Generator
Each note played is sounded twice Soft Thru On
Local On
Local On
Sound is emitted
Sound Generator
Local Off
No sound produced
Sound Generator
Value Description
On
Local Control is switched on.
Off
Local Control is switched off.
RG-3M_e3.book 107 ページ 2008年3月25日 火曜日���午前10時1分