12
Getting Ready to Play
Removing the Batteries
To remove the batteries, switch off the RMP-12’s power, detach
the battery cover, and pull the end of the battery tie to remove
the batteries.
The batteries may fly out if you pull too strongly on a
battery tie. Use caution when removing the batteries.
Battery Lifespan
When the batteries run down, the battery indicator in the upper
left of the screen will blink. The power will turn off five seconds
after the “Batt Low!” indication appears. Please replace the
batteries as soon as possible.
A ROLAND PSB-series AC adaptor (sold separately) can be used to
power the RMP-12.
1.
Make sure that the power for the RMP-12 is
switched off.
2.
Connect the power cord to the AC adaptor.
3.
Connect the AC adaptor to the RMP-12’s DC IN
jack, and plug the power cord into an AC outlet.
fig.ACadaptor.eps
Place the AC adaptor so the side with the indicator (see
illustration) faces upwards and the side with textual
information faces downwards. The indicator will light
when you plug the AC adaptor into an AC outlet.
Use only the ROLAND PSB-series AC adaptor. Other
adaptors may cause malfunction or damage to the
RMP-12 and must never be used.
• The reading of the battery indicator is an
approximation.
• When replacing the batteries, use AA alkaline batteries
(six batteries).
• Do not mix new and old batteries.
• When using alkaline batteries, their lifespan for
continuous operation at room temperature will be
approximately 8 hours. (This will vary depending on the
conditions of use.)
• Remove the batteries whenever the unit is to remain
unused for an extended period of time.
Connecting the AC Adaptor (Sold Separately)Indicator
to AC Outlet
Power Cord
AC Adaptor
RMP-12_e.book 12ページ ２００８年７月１１日 金曜日 午前９時４５分