15
Getting Ready to Play
Attachment 1.
Using the drum key included with the RMP-12 or a
commercially available drum key, loosen the
screws (A, two locations) by approximately 10 mm.
fig.1j
* Avoid placing fingers inside the holes in which the J-rods are
inserted.
2.
Loosen the screws (B, two locations) that hold the
J-rods of the marching carrier in place—just
enough to make it possible to move the J-rods.
* Do not remove the screws (B) that hold the J-rods in place.
fig.2j
3.
Insert the OP-RMP12 into the J-rods.
Insert it all the way, with the front and back oriented as
shown in illustrations.
fig.4j
4.
Adjust the J-rods so that the OP-RMP12 is
horizontal and parallel.
fig.4j
5.
Fasten the J-rods by tightening the screws you
loosened in step 2.
fig.j
6.
While making sure that the J-rods are inserted all
the way, securely tighten the screws on the OP-
RMP-12 that hold the J-rods in place.
fig.4j
* If the J-rods are not inserted all the way into the OP-RMP12,
the OP-RMP12 cannot be fastened securely, causing the risk
that it may come off of the J-rods while you perform.
7.
Put the marching carrier onto your body.
8.
Turn the lock levers (C, two locations) so they're
unlocked.
fig.j
A
10mm
B
Parallel
A
Locked
Unlocked
C
RMP-12_e.book 15ページ ２００８年７月１１日 金曜日 午前９時４５分