About Placement

Using the Unit While Mounted in a Rack

If you want to mount the S-OPT in a rack, make sure to use only the BOSS RAD-50 Rack Mount Adaptor (sold

separately). To install, secure the S-OPT to the RAD-50 with three screws, one is screw supplied with the RAD-

50 and another two screws are supplied with the S-OPT.

S-OPT

RAD-50

Using the REAC Connector Cover

If using commercially available Cat5e Ethernet cables, attach the supplied REAC connector cover to the connector.

* Remove the REAC connector covers if you are using REAC cables with EtherCon type connectors (the REAC cable which comes with the S-OPT or SC-W100S). Take care not to lose the REAC connector covers removed at this time.

Attaching the Rubber Feet

Attach the rubber feet when not rack mounting the unit.

Peel off the backing from the double-sided adhesive tape on the rubber feet and attach the feet at the points indicated in the figure below.

When turning the S-OPT upside down, place stacks of newspapers or magazines to support the four corners (or two sides) so that stress is not placed on the S-OPT itself. Also, handle the S-OPT with care, and avoid dropping it.

bottom of the unit

10

Page 10
Image 10
Roland S-OPT owner manual About Placement, Using the Unit While Mounted in a Rack, Using the Reac Connector Cover