5 port External Power Gigabit Switch RC409 | User Manual |
| | |
Features
z5 Gigabit Ethernet Ports with No-blocking Wire-speed Performance
zOne tri-speed RGMII/GMII
z136 kilobytes on-chip frame buffer
zOn-chip 8051 CPU
zJumbo Frame Support at all speeds
z8K MAC Address
zFull Duplex Flow Control(IEEE Std 802.3x™) and Half Duplex Back pressure
Front Panel LED Indications
LED
POWER
1000M LINK/ACT
100M LINK/ACT
Description
Power On
A valid connection with 1000Mbps
Receiving Packets
A valid connection with 100Mbps
Receiving Packets
Hardware Installation
This device will work with all OS’ s because there is no configuration needed for this stand-alone device. This switch has auto MDI-X ports that will auto-sense the cable type that you are using for each port. The switch will then automatically change the polarity of the port as need to ensure a link with either a straight-through or crossover cable. Remember, if you have a link light then you are using the correct cable. When connecting to a Gigabit device a straight-through Ethernet cable will always be used. Gigabit does not use uplink ports or crossover Ethernet cables. This is because Gigabit uses all 5 wires of an Ethernet cable, instead of 4 wires like 10/100.
