Rosewill RNX-GX4 user manual Secondary AP Setup

Wireless Router RNX-GX4 User’s Manual

hAuthentication Type: The default is set to “Auto Select”, which allows “Open System” or “Shared Key” authentication to be used. Select “Shared Key” if you only want to use “Shared Key” authentication (the sender and recipient both must use the same WEP key for authentication).

hFragmentation Threshold: This value specifies the maximum size for a packet before data is fragmented into multiple packets. You should leave this value in the 256 to 2346 range. In most cases, it should remain as its default value of 2346. Setting the Fragmentation Threshold too low may result in poor network performance.

hRTS Threshold: You can set RTS Threshold value in this field, the valid range should be 256-2347 and default value is 2347. If a network packet is smaller than the preset RTS threshold size, the RTS/CTS mechanism will not be enabled.

hDTIM Interval: The “DTIM Interval” indicates the interval of the Delivery Traffic Indication Message, you can set this value in the 20-1000 range, and the default value is 100.

hTransmit Rate: Transmit rate indicates the transmission speed of wireless LAN access .The default setting is “Auto” and you can set this value between 1 – 54Mbps range.

h802.11g Protection: Using 802.11b and 802.11g mixed mode may result in poor network performance. By enabling the 802.11 protection, it will improve performance of 802.11g devices in your wireless network.

hPreamble Type: "Short Preamble" is suitable for heavy traffic wireless network which will significantly increase the throughput performance at higher data rates. While "Long Preamble" provides more communication reliability and will ensure maximum stability of the connection; the default setting is “Long Preamble”.

hAP Isolation: Create separate virtual networks for your wireless network. After enable this function, every wireless client will in its own virtual network and can not access each other. If many users access your wireless network frequently, you should enable this function.

3.5.2 Secondary AP Setup

Secondary AP Setup defaults as Disable, when you enable it, this function will look very similar to the Primary AP Setup. However, please do name the SSID

36