Rotel RA-932 Troubleshooting, Specifications, Power Indicator Is Not Lit, Fuse Replacement

Troubleshooting

Most difficulties in audio systems are the result of incorrect con- nections, or improper control settings. If you encounter problems, isolate the area of the difficulty, check the control settings, deter- mine the cause of the fault and make the necessary changes. If you are unable to get sound from the RA-932 refer to the sugges- tions for the following conditions:

Power Indicator Is Not Lit

The Power Indicator should be lit whenever the RA-932 is plugged into the wall power outlet and the Power Switch is pushed in. If it does not light, test the power outlet with another electrical de- vice, such as a lamp. Be sure the power outlet being used is not controlled by a switch that has been turned off.

Fuse Replacement

If another electrical device works when plugged into the power outlet, but the Standby Indicator still will not light when the RA-932 is plugged into the wall outlet, it indicates that the internal power fuse may have blown. If you believe this has happened, contact your authorized Rotel dealer to get the fuse replaced.

No Sound

Check the signal source to see if it is functioning properly. Make sure the cables from the signal source to the RA-932 inputs are connected properly. Be sure the Listening Selector is set to the proper input.

Check the wiring between the RA-932 and the speakers.

English

Specifications

Continuous Power Output	35 watts/ch
(20-20 kHz, < 0.03%, 8 ohms)
Total Harmonic Distortion (20Hz-20kHz)	< 0.03% at rated power,
	1/2 power or 1 watt
Intermodulation Distortion (60 Hz : 7 kHz, 4:1)	< 0.03% at rated power,
	1/2 power or 1 watt
Frequency Response	20Hz-15kHz, ±0.3dB
Phono Input
Line Level Inputs	10Hz-40kHz, ±1dB
Damping Factor (20-20,000 Hz, 8 ohms)	180
Input Sensitivity / Impedance	2.5mV / 47 kOhms
Phono Input
Line Level Inputs	150 mV / 20 kOhms
Input Overload	180mV
Phono Input
Line Level Inputs	5V
Tone Controls - Bass /Treble	±6 dB at 100Hz / 10kHz
Signal to Noise Ratio (IHF “A” weighted)	80 dB
Phono Input
Line Level Inputs	100 dB
Power Requirements	115 Volts, 60 Hz
USA Version
European Version	230 Volts, 50 Hz
Power Consumption	180 Watts
Dimensions (W x H x D)	440 x 92 x 347 mm
	173/8 x 35/8 x 1311/16”
Weight (net)	5.5 kg, 12.1 lbs.

All specifications are accurate at the time of printing.

Rotel reserves the right to make improvements without notice.

9