
10RR-969
Special Buttons 




Five rectangular buttons behind the sliding cover are used for programming the
Configuration Buttons 



Four recessed buttons behind the sliding cover are used in configuring the unit. These buttons are recessed to prevent pressing them accidentally. Use the tip of a ballpoint pen to press them.
Operating the RR-969
This section of the manual explains the basic operation of the
NOTE: The
Sending IR Commands
Instead of putting down one remote and picking up another, you simply press a button on the
1.Press a DEVICE button to activate the command set for the desired component. For example, press the AUD button for a Rotel surround processor. The label for your selection appears in the display. The selected command set remains active until you press a different DEVICE button.
2.Press a COMMAND button to send an IR command to the component you have selected. For example, press the POWER button to turn on or off a Rotel surround processor. The label for the COM- MAND button appears in the display. If the label “EMPTY” appears in the display, the button has no learned command for that DEVICE.
NOTE: The default labels that appear in the display match the button labels. You can customize the labels for ev- ery DEVICE and COMMAND button.
Remember that the COMMAND buttons duplicate con- trols on many different types of audio/video compo- nents. Their function depends on the type of component selected. Make sure that you have pressed the correct DEVICE button and use the button labels and LEAF OVERLAY as guides.
English 11
Sending Macro Commands 
Twenty of the buttons on the fol- lowed by the button where the macro is stored.
Multi-Step Button Operation 

The POWER Button and the five buttons labelled SHIFT, PTY, TA, TP, DISPLAY provide a special option – the ability to program up to three different commands. The first command is sent when the button is pressed once, the second command is sent the next time the button is pressed, and the third command is sent the third time the button is pressed.
LIGHT Button 
In a dark room, the
KEY TONE Button 
The indi- cator appears in the display. Press the
/CLONE button to toggle this feature on or off.
Time/Alarm Feature 
The
Press the TIME/ALM button to turn the alarm function on or off. When the alarm function is activated, an alarm indicator is shown in the display.
To set the TIME:
1.Press the EDIT button followed by the TIME/ALM button. The hour digits of the display flash and SET HOUR appears in the display.
2.Press the UP or DOWN buttons to set the correct hour. Advancing the hour sequentially steps through two options:
3.When the hour is correct, press the + button to advance to the next step. The minute digits of the display flash and SET MINUTES appears in the dis-