Rover Mowers Limited |
3.8 Outlet Chute Installation
|
| WARNING |
|
|
|
|
|
|
|
|
| When working on the cutterhead |
|
|
|
| the mower must be: |
|
|
| ∙ Stationary with the park brake |
|
| |
| ∙ | applied |
|
|
| The engine switched off |
|
| |
| ∙ | The ignition key removed. |
|
|
|
|
|
| |
1. Raise the stone guard (A) fitted to the mower |
| |||
cutterhead and slip the tongue (B) of the |
| |||
outlet chute between the stone guard and the |
| |||
mower cutterhead. |
| |||
(Refer Figure 3.7) |
| |||
2. Lower the cutterhead stone guard (A) and slide |
| |||
the outlet chute rod (C) into the tongue of |
| |||
the outlet chute. |
| |||
3. Retain the outlet chute rod by fitting the small | Figure 3.8 - Fitting the Transfer Tube | |||
spring clip (D) into the eye of the rod. |
| |||
|
| 3.10 | Skirt Installation – | |
|
|
|
| (Model 198 cutterhead only) |
1. Raise the cutterhead of the mower to the highest cut position.
2. Position the skirt on the underside of the front of the cutterhead and attach using the two 5/16” x 3/4“ cuphead bolts (A), pushed in from the underside of the cutterhead so that the flat washer (B) and nyloc nut (C) are on the top side of the cutterhead.
(Refer Figure 3.9)
Figure 3.7 – Outlet Chute Installation
3.9 Grass Transfer Tube
1.Hold the grass transfer tube by the handle (A) and slide the tube into the opening in the front panel of the grass catcher front plate. Then slide the tube forward over the open end of the outlet chute till it engages with the stop on the outlet chute.
(Refer Figure 3.8)
2.Retain the tube by clipping the elasticised strap
(B)on the outlet chute over the retaining
button on the transfer tube (C). | Figure 3.9 - Skirt Installation |
(Refer Figure 3.8) |