Rover 108, 109 Mounting the Grass Catcher, Grass Catcher Model, 3 - Grass Catcher Support

Rover Mowers Limited Ride-on Mower Grass Catcher

3.5 Mounting the Grass Catcher

The grass catcher is supported off the rear towbar of the Rover Rancher, Raider and Lawn King ride-on mowers. Refer figure 3.3.

l. Lift the grass catcher assembly onto the mower, positioning the support saddles on the rear towbar on the mower.

2.Secure the grass catcher to the support bracket by two 3/8" x 1" unc bolts and 3/8" unc nycloc nuts. Placing a 3/8" flat washer under the nut and bolt head.

Grass Catcher

Model 108 8109

Figure 3.3 - Grass Catcher Support

Figure 3.4 - Mounting the Catcher Assembly

3.6 Frame Assembly

The internal frame assembly consists of the two side frames (A) and spreader plate (B)

These components are fastened together using '/,6' x 1

"round head screws (C) and '/16" unc. nyloc nuts (D) (Refer Figure 3.5).

Figure 3.5 - Internal Frame Assembly

3.7 - Frame Installation

1.With the grass catcher assembly mounted on the mower, open up the grass catcher fully. To hold the grass catcher open, tighten the pivot bolts. (Refer Figure 3.6)

2.Insert the internal frame assembly (A) into the grass catcher, aligning the mounting holes on the internal frame over the locating bolts on the catcher assembly.

3.Secure using four I/4" nyloc nuts (B). (Refer Figure 3.6).

4.Loosen the two pivot bolts so that the catcher bag assembly swings easily.

Figure 3.6 – Frame Installation