Royal Appliance 016 DO NOT OPEN, DO NOT REMOVE COVER (OR BACK), RISK OF FIRE OR ELECTRIC SHOCK, NO USER-SERVICEABLEPARTS INSIDE, Trouble, Solution, does not start

78	IMPORTANT SAFEGUARDS
	IMPORTANT SAFEGUARDS

95 TROUBLESHOOTING

Trouble Possible causes Solution

When using your coffee maker, basic safety precautions should always be followed, including the followed to reduce the risk of fire, electric shock, and/or injury to persons including the following:

1 ● Read all instructions.2 ● Do not touch hot surfaces. Use handles or knobs.

3 ● To protect against electric shock, do not place cord, plug or appliance in water or other liquid.

4 ● Close supervision is necessary when any appliance is used by or near children. 5 ● Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and

damaged in any manner. Return appliance to an authorised service facility for examination, repair or adjustment.

7 ● The use of an accessory not evaulated for use with this appliance may cause injuries.

8 ● Do not use outdoors.9 ● Do not let cord hang over edge or table or counter, or touch hot surfaces.10 ● Do not place on or near a hot gas or electric burner, or in a heated oven.

11 ● Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any control to the off position, then remove plug from wall outlet. 12 Use this appliance only for its

No message is displayed	The machine is not getting power
	The service door is open
The automatic coffee brewing	BREW UNIT MISS.
does not start
	BREW UNIT BLOCK.
	WATERTANK	COF. BEANS
	EMPTY	EMPTY

The automatic coffee brewing	DREGDRAWER MISS.
does not start
	GRINDER BLOCKED

Turn the main switch on, check plug and fuseClose the service door is Properly fit and lock the central unitClean the central unit (see page 91)Fill with water or coffee beans and restart the cycleFit the coffee grounds container properlyService the coffee grinder (see page 92)

before cleaning the appliance.

6 ● Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been

●

intended use as described in this manual. 13 ● Keep the cord away from heated surfaces.

Steam and hot water are not dispensed

Coffee is dispensed too quickly

Coffee is dispensed too slowly

The steam/hot water spout hole is cloggedGrinding too coarseGrinding too fine

Clear the hole with the aid of a thin needle

Adjust the grinder on a finer grinding, e.g. from 5 to 3 Adjust the grinder on a coarser

SAVE THESE INSTRUCTIONS

WARNING

RISK OF FIRE OR ELECTRIC SHOCKDO NOT OPENWARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.DO NOT REMOVE COVER (OR BACK)NO USER-SERVICEABLE PARTS INSIDEREPAIR SHOULD BE DONE BY AUTORIZED SERVICE PERSONNEL ONLY

Coffee is not hot enoughCoffee is not creamy enough

The machine coffee brewing is reduced, it takes longer to heat and the dispensing is not sufficient The central unit cannot be removed

The central unit filter is clogged The cup has not been preheated

The coffee blend is not suitable or is not fresh. Grinding is not correct (too fine or too coarse)

Descaling the machineThe central unit has not been correctly positioned

grinding, e.g. from 5 to 7 Clean the filterHeat the cup on the heating plateTry another coffee blendDescale the machine, as described at page 92

Switch the machine on, close the service door, fit the coffee grounds container and wait until the machine resets.