Royal Sovereign RSS Series, RSH-1650 Mounting, Lay the decaled image face down on a flat surface

13.3 Mounting

1. Lay the decaled image face down on a flat surface.

Carefully peel back and put a crease along the edge of

the release liner (Approximately 1 in or 25mm, Figure 1).

RSS, RSR, RSH Series

14.INSTALLATION OF FRONT FEEDER and REAR REWINDER OPTIONS

Figure 1

2.With the image facing up, align the image onto the board. Press firmly from the center out (Figure 2).

Figure 2

NOTE: Below options are to be installed by an authorized RS reseller.(These options are available for the RSH-1650.)

Installation of the Front Feeder Option (Includes 2 brackets, one spindle, and mounting hardware).

1.Install the Front Feeder to the inside of the front frames using four 1/4" (M6) hexagon bolts on each side (Figure 1)

Installing the Rear Rewinder Option (Includes motorized winder, bracket, one spindle, and mounting hardware).

1.Remove the left and right covers by using a screwdriver (four screws on each side cover) (Figure 2 & 3).

Figure 1

Figure 2 Figure 3

3.Adjust the pressure lever to ensure the proper opening (Figure 3).

2. Remove the lever knob screw and lever (Figure 4).

4.Flip the image over the upper roller and hold on to the release liner (Figure 4).

5. Depress the foot pedal once, and then let it go while slowly pulling the release liner as the board enters the main roller nip (Figure 5).

Figure 3

Figure 4

3.	Remove the rear cover by removing all	Figure 4
	10 screws (4 top, 4 bottom, and 1 on
	each side) (Figure 5 & 6).
	Figure 5	Figure 6
4.	Disassemble the power switch bracket and place the left
	rewinder outside of the frame; fasten with round head
	3/16"(M5) screws (included in the option kit). Then, reinstall
	the power switch bracket (Figure 7).
5.	Install the right rewinder on the outside of the frame and
	connect the motor wire connector to the rear wire	Figure 7
	(Figure 8 & 9).

Depress the foot pedal once again when the board has completely exited from the rear of the unit.

Trim the board if necessary.

Figure 5

15

6.Reinstall the rear cover.

7.Reinstall the side covers.

8.Reinstall the lever knob and screw.

Figure 8 Figure 9

16