Rubbermaid WD12.5G owner manual 11 G

Assembly
1		Tools needed
		10mm	13mm
		FF
	HH	x4	10mm
	x4
F	GG		13mm
Q	x4

Attach axle support to cart frame using small screws, star washers, and small nuts. Hand tighten.

2

F

Q

Turn cart frame over. Note orientation of notch in axle support.

7	2
KK	1
	MM
	LL

Attach bolt, lock washer, and nut to wheel shaft support. Use 13mm socket wrench and box end wrench to fully tighten.

ENGLISH

8

M

1

2

Attach tank retaining bracket to wheel shaft support. Align lower tab with slot. Tighten tank release knob halfway.

3

P x2

	GG
	x2
FF
x2	HH
	x2

4 x2 N

FF

GGx2

x2

HH

x2

9

10
FF x2
1	HH x2
O
	GG
	x2
	2

Attach vertical supports to side of cart frame using small screws, star washers, and small nuts. Ensure support nests are pointed towards front of cart. Hand tighten.

Align diagonal supports with holes on side of cart frame (while ensuring spring loaded buttons face inside of cart). Attach diagonal supports to cart frame using small screws, star washers, and small nuts. Hand tighten.

Lay cart back.	Attach tank brace to wheel shaft support using small screws,
	star washers, and small nuts. Use 10 mm socket wrench
	and box end wrench to fully tighten. FULLY TIGHTEN ALL
	SCREWS ON CART!

5

II x2	JJ
	x2

GG

x2

6

11 G	GG
x2
	x4
1

FF

x4 HH

x4

1

Open end

2

12

D

Attach diagonal supports to vertical supports with black coated	Use 10mm socket wrench and box end wrench to fully tighten
screws, star washers, and black coated nuts. Hand tighten.	all screws, star washers, and nuts.
	8

Attach caster brackets to front of cart frame using small screws, star washers, and small nuts. Ensure open end of caster brackets face down. Use 10 mm socket wrench and box end wrench to fully tighten.

Flip frame over. Check that frame is properly assembled. Temporarily place tank on frame. Important: Ensure cart is

9assembled correctly before proceeding.