Rubbermaid WD12.5G owner manual Liquid Overflow Protection, Replacing Hepa Filter Hepa Foam Sleeve

Emptying Wet Tank

1

Disconnect power cord from outlet.

2

1

2

Unscrew and remove drain cap.

Liquid Overflow Protection

When either tank is full of liquid, the automatic shut-off mechanism will turn off vacuum cleaner motor. The automatic

shut-off mechanism will also engage if the vacuum cleaner has been tipped over. If tank(s) are full, turn vacuum cleaner off and empty tank(s) to continue use. If vacuum cleaner has been tipped over, turn vacuum cleaner off and set upright. Wait a few seconds to allow the motor to come to a complete

stop before turning back on.

ENGLISH

Replacing HEPA Filter/

HEPA Foam Sleeve

1

Disconnect power cord from outlet.

3

4

2

1

2

A

2

1

3

1

Y

2

X

3

A

Empty contents into suitable drain or container. Tilt vacuum cleaner to allow any remaining liquid to drain.

Reinstall drain cap. (Vacuum cleaner is now ready for use.)

Release latches. Remove powerhead.

Turn powerhead upside down. Remove old HEPA filter/HEPA foam sleeve.

Blower Mode Operation

1

2

U

1

2

4

Y

2 X

1

A

3

5

A

1

2

Disconnect power cord from outlet.

Insert hose into blower inlet and turn clockwise to lock. (Blower is now ready for use.)

16

Slide new HEPA filter onto float cage, ensuring that it is fully
seated onto powerhead. Slide HEPA foam sleeve over HEPA
filter. Turn powerhead right side up.	17

Reinstall powerhead. Fasten latches. (Vacuum cleaner is now ready for use.)