RuggedCom manual Disable RSTP, Reset the RS900W switches, Login to the ROS console

b- Enter <CTRL+S> to access the ROS shell prompt

c- Type “version” command and you should see something like “ROS v3.5.0” (or higher) reported to the display.

1.3.4 Step 4: Disable RSTP:

a- Goto Main Menu

b- Ensure that Spanning Tree -> Configure Bridge RSTP Parameters -> State -> Disabled is selected.

c- Save the setting by pressing <CTRL+A>

1.3.5Step 5: Upgrade the IEEE 802.11 (Wireless) daughter-card firmware on RS900W switch(es):

a- Goto “Main Menu”

b- Verify that the wireless interface and TFTP server reside on the same IP

subnet. WLAN Interface -> Addressing Parameters -> IP Address c- Ensure that WLAN Interface -> Miscellaneous Parameters -> TFTP Server Address -> Enter IP address of TFTP server is configured

d- Ensure that WLAN Interface -> Miscellaneous Parameters -> Software Upgrade -> Select Start is selected.

e- Save the setting by <CTRL+A>

f- At this point the IEEE 802.11 (Wireless) daughter-card firmware upgrade will start. Check WLAN Interface -> Miscellaneous Parameters -> Software Upgrade Status to see the firmware upgrade status information.

g- Please note that it will take up to 15 minutes to complete.

1.3.6Step 6: Reset the RS900W switch(es)

1.3.7Step 7: Login to the ROS console

a- Login as an “admin”

b- Enter <CTRL+S> to access the ROS shell prompt

1.3.8Step 8: Verify the IEEE 802.11 (Wireless) daughter-card firmware version:

a- Wait until wireless interface is up and running by monitoring the Port 9 LED on the front panel. When the LED is lit, the wireless interface is available.

b- Select WLAN Interface -> Miscellaneous Parameters -> Version

c- You should see something like “WLAN-FS.1.6-APP.1.6” reported to the display.

5

© 2007 RuggedCom Inc. All rights reserved Rev100