Runco LS-7 operation manual 7. Source Select Sub-Menu, Operation

Operation

Source Select: To select a video source, press or to highlight Source Select, then press ENTER. This displays the Source Select sub-menu, shown in Figure 4-7.

The default source selection is HDMI 1. All sources that are not available per the source enable function (refer to Source Enable on page 52) are grayed out.

Figure 4-7. Source Select Sub-Menu

PIP Select: To select a PIP (secondary) video source, press or to highlight PIP

Select, then press ENTER. The default PIP selection is Off.

All sources that are not available per the source enable function (refer to Source Enable on page 52) are grayed out.

All sources that cannot be used for PIP due to a shared electronic path with the Active source are grayed out. The PIP source is a saved setting for each source, like brightness and contrast.

If for some reason the current PIP source becomes invalid (by disabling it in the source enable menu, for instance), PIP Select automatically resets to Off.

Resync: If the projected image becomes unstable or degraded, press or to highlight Resync, then press ENTER. This causes a re-acquisition of the active source and the PIP source, if present. It also changes any Fine Sync settings (described on page page 49) for this timing to the default setting.

44 Runco LS-7 Installation/Operation Manual