Runco PFP-11, Vivix Pixel for Pixel, PFP-7 manual Remote Control Description, Power Button

REMOTE CONTROL DESCRIPTION

A.IR OUTPUT INDICATOR

Illuminates when a button is pressed, indicating that an IR signal is being transmitted.

B.POWER BUTTON

Toggles the power on and off. For a discreet on or off command, you can use the direct access buttons (see 'J'). Note: When the main AC power switch is first turned ON, the processor will go through an initiation cycle for approximately 15 seconds. The processor cannot be turned on or operated until the initialization is complete.

C.UP BUTTON

When no menus are present on-screen, the UP button will toggle you through aspect ratios in the following order:

Standard (4:3) Letterbox Anamorphic

When the menu is on-screen, the UP button will move the cursor up within the menu. When an adjustment item has been selected (i.e. brightness), the UP button will increase the value of that function.

D.LEFT BUTTON

When no menus are present on-screen, the LEFT button will toggle you through the four different sources in the following order:

Pass-through Component S-Video Composite

E.DOWN BUTTON

When no menus are present on-screen, the DOWN button will toggle you through aspect ratios in the following order:

Anamorphic Letterbox Standard (4:3)

When the menu is on-screen, the DOWN button will move the cursor down within the menu. When an adjustment item has been selected (i.e. brightness), the DOWN button will decrease the value of that function.

F.RIGHT BUTTON

When no menus are present on-screen, the RIGHT button will toggle you through the four different sources in the following order:

Composite S-Video Component Pass-through

G.MENU BUTTON

Pressing the MENU button will bring up the main menu. If no action is taken within approximately 10 seconds, the menu will time-out (disap- pear). Also, if you are in an adjustment mode or function, pressing MENU will bring the menu back one level.

H.ENTER BUTTON

When an item is highlighted on a menu, pressing ENTER will select that item.

I.PROGRAM BUTTON

If the remote control loses its 'memory' as a result of weak or dead bat- teries, it must be re-programmed for the PFP-7/PFP-11'scode set. To reprogram the remote, press the PROGRAM button followed by 0,1,3.

Note: Pressing Enter after typing in the code is not necessary.

APWRB

C

				G
	I		I
D	N	M	N	F
	P		P
	U		U
	T		T
I				H
E
	1	2	3
ON	4	RUN0 CO	6	J
		5
	7	8	9
OFF

J.DIRECT ACCESS BUTTONS

These buttons will allow you to directly access an aspect ratio, source, or turn the unit on or off without having to go through any menus. These buttons are:

1:Selects COMPOSITE video

2:Selects S-video

3:Selects COMPONENT video

4:Not used

5:Selects PASS-THROUGH

6:Enables or Disables the Installation Menu (see page 18)

7:Selects the ANAMORPHIC aspect ratio

8:Selects the STANDARD (4:3) aspect ratio

9:Selects the LETTERBOX aspect ratio

0:Turns the processor ON.

OFF: Also known as the button left of '0', this turns the processor OFF.

10