Rear Panel

1 5

12V FUSE

		RGB VIDEO OUTPUT						VIDEO INPUTS
RS-232 IN	V	H	B	G	R	PASS THROUGH	Y	Pr	Pb S-VIDEO COMPOSITE

MASK SCREEN

12V TRIGGER

RUNCO INTERNATIONAL

HAYWARD, CA

AC 120V 60Hz, 15W

MADE IN USA

1.12v Fuse

This fuse protects the 12v outputs from the MASK and SCREEN jacks. (Screen Fuse: 5mm x 25mm, AGC, 0.5A 250V Fast Acting, 250V, Fast Blow)

2.Mask

This is a 12V output that is used to trigger masking on screens that have that capability. (For use on motorized screens only).

3.Screen

This is a 12V output that is used to trigger the screen to drop. (For use on motorized screens only).

4.RS-232 In

This is for systems using serial (RS-232) to control the PFP-7/PFP-11.

5.Reserved for future use.

6.RGB OUTPUT

This is the main output of the PFP-7/PFP-11. The RGB Signal goes directly to the display; If component is used through the pass-through, then only the R (Pr), G(Y) and B(Pb) jacks will be active. Individually, the jacks are: V=vertical sync, H=horizontal sync, B=Blue, G=Green, R=Red.

Note: If setting the output for ‘sync on green’ or ‘component’ (see Installation Menu section); disconnect the sync cables (H & V) from the processor. If using composite sync, the sync output will be on the ‘H’ connector.

7.Pass-through

Anything input to this port will by-pass the processing of the PFP-7/PFP-11and be sent straight to the display. This is useful for computer graphics and HDTV signals which do not require processing.

8.Component Input

This is the input for component video from sources such as DVD players.

Note: The component output from a DTV decoder or a progressive-scan DVD cannot be used with this port; it must be input to the Pass-through port.

9.S-Video Input

This is the input for S-video from sources such as Satellite receivers, S-VHS VCR’s and DVD players.

Runco Vivix Pixel for Pixel, PFP-7, PFP-11 manual Rear Panel, RGB Video Output Video Inputs

Models: Vivix Pixel for Pixel PFP-7 PFP-11