![](/images/new-backgrounds/1117224/11722445x1.webp)
Installation Menu
Installation Menu
The Installation menu is where you can adjust the Picture Orientation, Keystone, Lamp Output, and even check the age of the lamp in the Projector.
When the Controller is turned on for the first time, the INSTALLATION item will not appear in the main menu. To enable the INSTALLATION menu, there are two options:
1)With the processor ON and no menus
2)With the remote control, press button 6 (with no menus
After INSTALLATION has been accessed, press MENU, highlight INSTALLATION and press ENTER. This will bring up the INSTALLATION MENU, shown on the right:
INSTALLATION
Lamp Mode
Keystone
Picture Orientation
IR Code Set
Lamp Hours | 20 |
Lamp Mode
The Lamp Mode enables the installer to set the lamp for full brightness (normal) or Low (20% lower). If a small screen is being used in a dark area or the image is otherwise too bright, it may be a good idea to set the Lamp Mode to LOW. When the Lamp Mode is set to LOW, the lamp will last longer as a result of the lower current setting.
Keystone
KEYSTONE: Corrects the trapezoidal distortion that results from projecting at an angle:
An image with Keystone error | A correctly adjusted image |
This may occur in installations where the projector needed to be angled as a result of a larger vertical offset. This keystone feature will correct for trapezoidal distortion for as much as a 15° projector angle.
Picture Orientation
This will set the orientation of the image for your installation. If the Projector will be mounted on a table, set this for Floor. If mounting it on the ceiling, select Ceiling. For
21