Russound CA-LCD.2, CA-KP.2, CA 6.4i instruction manual Warranty, Combining Additional IR Receivers

COMBINING ADDITIONAL IR RECEIVERS

When combining a CAi Series multi-source controller and a secondary IR system together, it needs to be done after the CAi System. The IR information from the keypad is on Pin #2. This signal is demodulated at the keypad and is re-mod- ulated at the processor then sent to the emitter out-puts. Combining a modulated IR signal to this lead (#2) will not work because it is already modulated. The following method should be used to assure correct integration with such com-

TROUBLESHOOTING

LINK

IN OUT

GROUND

SIGNAL

ponents.

Simply plug the IR linking cable supplied with the CAi prod- uct into the IR “Link Out” jack on the CAi and plug the other end into the Russound 857 IR Connecting Block’s “IR Common In”. The secondary IR receiver can either be wired to the terminal block as shown or plugged into the “IR Reciever In” via an 1/8” mini-plug. The emitters that would have been connected directly to the CAi system will now be plugged into the connecting block.

This method combines the modulated IR signal at the con-

TO SECOND

IR RECEIVER

857 CONNECTING BLOCK

						CONNECT TO
						846C POWER
						SUPPLY
SIGNAL DESIGNED	STATUS	GND	+12VDC	IR COMMON IN	IR RECEIVER IN	POWER +12VDC	STATUS +12VDC
IN USA
MADEIN				ONFIRMC IR		LOCK ONNECTING
						B	C
						NFRAREDI 857
KOREA				MITTERSE
	6		5	4	3	2	1

necting block then distributes it to the six emitter ports.

845.1MICRO EMITTERS TO IR CONTROLLED

EQUIPMENT

WARRANTY

The Russound CAi-Series Controllers are fully guaranteed for Two (2) years from the date of purchase against all defects in materials and workmanship. During this period Russound will replace any defective parts and correct any defect in workman- ship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit must be returned to Russound at the owners expense and with prior written permission. Accidental damage and shipping damage are not considered defects under the terms of the warranty. Russound assumes no responsibility for defects resulting from abuse or servicing performed by an agency or person not specifically authorized in writing by Russound. Damage to or destruction of components due to improper use voids the warranty. In these cases the repair will be made at the owners expense. To return for repairs, the unit must be shipped to Russound at the owners expense, along with a note explaining the nature of the service required. Be sure to pack in a corrugated container with at least 3 inches of resilient material to protect the unit from damage in transit.

15