Russound SUB105 instruction manual Installation, Rear Panel

INSTALLATION

2

1

7

3 4

5

6

Rear Panel

1SPEAKER LEVEL OUT – Pass-through connectors for main left and right speakers when speaker- level input is used. Binding posts accept banana plugs, spade lugs, pin connectors, and bare wire up to 12 AWG (2.05 mm).

2SPEAKER LEVEL IN – Connectors for speaker-level signals from an amplifier or receiver. Binding posts accept banana plugs, spade lugs, pin con- nectors, and bare wire up to 12 AWG (2.05 mm).

3RNET A/V IN – RJ-45 connector for a balanced stereo line-level signal via CAT-5 cable from an RNET A/V source output or an RNET A/V Encoder.

4LINE-LEVEL INPUT – RCA connectors for stereo line-level signals from a preamplifier or receiver.

5LFE INPUT – RCA connector for a prefiltered low-frequency effects signal from a home theater receiver or processor.

6VOLTAGE SWITCH – Sets the amplifier to operate on either 120 V or 240 V. Set this switch to match the supply mains voltage.

7POWER CORD RECEPTACLE – Connector for the supplied power cord.

4