INSTALLATION (continued)
WARNING: ELECTRIC SHOCK HAZARD
All servicing requiring access to
DO NOT open any access panel which requires the use of tools. Failure to follow this warning can result in severe electrical shock.
M303 p/n 307590 OpManual
FRYER ELECTRICAL INSTALLATION
Fryers must be connected directly to an appropriately sized electric circuit. Conduit and strain relief must be provided by the electrician. Refer to equipment nameplate for voltage and amperage requirements.
If an equipment shutdown interface is required by local fire code, the flame sensor terminal block may be accessed by removing the back panel. Replace the jumper of the terminal block with wiring to a normally closed contact of the building fire management system.
DO NOT connect power to the flame sensor terminal block. Wiring and contacts must be capable of handling 30 amps.
CAUTION:
RISK OF
DAMAGE
DO NOT connect or energize this appliance until all installation instructions are read and followed. Damage to the appliance will result if these instructions are not followed.
CAUTION:
ELECTRIC SHOCK HAZARD
The ground lug of
IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty.
5