CHAPTER 2. Ошибка! Стиль не определен.

2.3 Installing in a Rack

This section describes how to install the OfficeServ 7100 cabinet inside a 19-inch rack.

2.3.1 Cautions for Installation

Take the following cautions when installing the OfficeServ 7100 cabinet inside a rack:

yThe 19” rack should be a standard electric equipment rack.

yWhen using an enclosed-type rack, check if the rack is properly ventilated. Vents should be equipped on the side of the rack and fans should be attached to ventilate cool air into the rack.

yFor the enclosed-type rack that the fan is attached on the top, beware that the hot-air generated in the system on the bottom part can go up and enters to the inlet port of the installed system.

yWhen using an open rack, do not block the entrance of a port or fan of the OfficeServ 7100 system.

2.3.2Tools Required

yA middle-sized Phillips screwdriver

yTwo brackets and six screws for attaching rack

yTwo clamp screws

Figure 2.1 Tools for the Installation inside a Rack

2.3.3 Installing in a Rack

The procedure for installing the OfficeServ 7100 cabinet inside a 19-inch rack is as follows:

1)Attach the cabinet bracket to the bottom surface of the OfficeServ 7100 cabinet and fasten the bracket firmly with the two screws.

Figure 2.2 Rack Installation (1)

2-2

© SAMSUNG Electronics Co., Ltd.

Page 26
Image 26
Samsung 7100 installation manual Installing in a Rack, Tools Required