Ryobi 4730301 manual Assembly, To Attach Front Extension Rail, To Attach Rear Extension Rail

ASSEMBLY

TO ATTACH FRONT EXTENSION RAIL

See Figure 2 and 4.

Remove end caps from right end of front rail on your BT3100/BT3100-1 table saw. See Figure 4.

Slide one of the T-nuts into bottom channel of front rail on your saw. Slide a second T-nut into back channel of front rail.

Attach one of the connectors provided to T-nut on bottom of front rail and secure with a washer (5/16 in.) and a hex bolt (5/16-18-x 1/2 in.). Finger tighten only.

Orient front extension rail so that it matches front rail of your saw. Place two T-nuts in matching channels of front extension rail.

Connect bottom T-nut to connector on front rail of your saw and secure with a washer (5/16 in.) and a hex bolt (5/16 in. x 1/2 in.). Finger tighten only.

Attach a second connector to back channel of front rail and front extension rail. Secure it to each T-nut with a washer (5/16 in.) and hex bolt (5/16 in. x 1/2 in.). Finger tighten only.

TO ATTACH REAR EXTENSION RAIL

See Figure 3 and 5.

The rear extension rail attaches to rear rail on your BT3100/ BT3100-1 table saw by repeating the above procedure for attaching front extension rail. The only difference being the rear rail has a different configuration. See Figure 3.

NOTE: There are several repetitive steps required for assembling this kit. Please study and review illustrations closely for clarification when asked to repeat a procedure.

After attaching rear rail extension to your saw you should now have the front and rear extension rails attached to your saw using four connectors, eight T-nuts, eight washers (5/16 in.), and eight hex bolts (5/16 in. x 1/2 in.).

Using a 1/2 in. socket or the small wrench supplied with your table saw, tighten all eight bolts securely. Assure the two rail sets are straight before, during and after tightening.

FRONT

EXTENSION RAIL

T-NUT	HEX BOLT
CONNECTOR
WASHER

TABLE BRACKET

FRONT RAILS

SHOWN ATTACHED

Fig. 2

REAR

EXTENSION RAIL

T-NUT

CONNECTOR

WASHER

HEX BOLT

TABLE BRACKET

SPACER

REAR RAILS SHOWN

ATTACHED

Fig. 3

5