Ryobi 4730301 manual To Attach Table Brackets, Auxiliary Table TOP not supplied

ASSEMBLY

TO ATTACH TABLE BRACKETS

Slide two T-nuts into channel on rear portion of front extension rail. See Figures 2 and 4.

Attach two table brackets and secure with washers (5/16 in.) and hex bolts (5/16 in. x 1/2 in.) supplied. Hand tighten only.

Slide two T-nuts into channel on front portion of rear extension rail. See Figures 3 and 5.

Place a spacer between table brackets and T-nuts on rear extension rail as shown in figure 5.

Secure table brackets and spacers with two washers (5/16 in.) and two hex bolts (5/16 in. x 5/8 in.) supplied. Hand tighten only.

NOTE: These bolts are longer to accomodate spacers. Spacers are needed to provide clearance for the rip fence when sliding along extension rails.

AUXILIARY TABLE TOP (not supplied)

We suggest you make the auxiliary table top from a piece of plywood cut 22 in. wide by 44 in. long by 3/4 in. thick.

Space table brackets on each of the four corners so that they are approximately 6 in. from the ends of extension rails. See Figures 4 and 5.

Place table top in desired position on table brackets and adjust table brackets as needed.

NOTE: End of table top closest to saw will rest on lip of accessory table. See Figure 6.

Tighten the four table bracket bolts securely.

Slide rip fence the entire length of extension rails to make sure it will clear your new extension table. Make adjustments as needed for clearance and smooth operation of rip fence.

Cut a piece of 2 x 4 approximately 19 in. long and secure to bottom of table top with wood screws. See Figure 8.

NOTE: Use flat head wood screws (not included) if attaching this piece thru table top. Make sure these screw heads are below the surface of table top. We suggest you mount it from underneath table top if possible.

This piece should also be located close to the end of your table top. We suggest that you turn it on its edge as shown in figure 8.

NOTE: Table legs will be secured to this piece of wood.

Reposition table top on table brackets and secure with wood screws (#10 x 5/8 in.) provided. See Figure 7. NOTE: These screws mount from underneath table top.

FRONT

EXTENSION RAIL

		TABLE
	BRACKET
END CAP	T-NUT	WASHER	HEX BOLT

Fig. 4

REAR

EXTENSION RAIL

SPACER

	TABLE
	BRACKET
WASHER	T-NUT
HEX BOLT	END CAP
	Fig. 5
ACCESSORY	AUXILIARY TABLE TOP
TABLE	(22 in. X 44 in. X 3/4 in.)

LIP

Fig. 6

AUXILIARY

TABLE TOP

TABLE

BRACKET

WOOD

SCREW

Fig. 7

6