ASSEMBLY
TABLE LEGS (not supplied)
See Figure 8.
Table legs can be made from either 2 x 4s or by purchasing a Ryobi Leg Set, #4730305, depending upon the application in which your saw is being used. For example, if your saw is being used in a permanent application you may want to use 2 x 4s which will be more sturdy and provide extra stability. The metal leg set may be preferable for portable applications or when moving your saw around in a workshop.
TABLE LEGS MADE FROM 2 X 4s
Option #1
Cut two 2 x 4 legs the exact length required to support extension table.
Make sure ends are cut perfectly square for better stability.
Place legs flush against bottom of table top and against 19 in. 2 x 4 attached to bottom of table top. See Figure 8.
Secure table legs to table top with wood screws or bolts, washers, and hex nuts (not included).
If extra bracing is needed, cut a scrap piece of wood and attach to bottom of table legs. See Figure 9.
Option #2
Option #2 will allow table legs to be adjusted to the proper height when your saw is used in portable applications, or in situations where the floor is not perfectly level. This option requires cutting a slot in top of table legs as shown in figure 8.
ADDITIONAL TABLE LEG OPTIONS
Additional options are also available for making table legs:
Option #3
If desired, table brackets can also be used for leg brackets. This option would eliminate the necessity of cutting slots in top of table legs for height adjustments.
NOTE: Additional table brackets are available and may also be purchased. Table brackets can be mounted upside down on table legs and secured to extension rails. Using the appropriate bolts, washers, and
Option #4
It is also possible to turn legs 90° from the way we have shown and attach to each end of the 19 in. 2 x 4 under table top. This option attaches similar to the way we have described above, however, because of very close dimensions, it is a more difficult procedure.
AUXILIARY
TABLE TOP
19 in. 2 X 4
TABLE LEG 
WOOD SCREWS
(NOT INCLUDED)
TABLE LEG OPTION # 1
TABLE LEG OPTION # 2 | TABLE LEG OPTION # 3 |
Fig. 8
OPTIONAL BRACE |
|
TABLE LEGS SHOWN |
|
ATTACHED TO AUXILIARY TABLE TOP | Fig. 9 |
7
