UNPACKING
WARNING:
Do not attempt to operate this tool until you have read thoroughly and understand completely all instructions, safety rules, etc. contained in this manual. Failure to comply can result in accidents involving fire, electric shock, or serious personal injury. Save this operator's manual and review frequently for continuing safe operation and instructing others who may use this tool.
INTRODUCTION
This kit gives you the capability of mounting a router on the accessory table of your saw. A router mounted on the accessory table will provide expanded capabilities for making rabbets, grooves, chamfers, dovetails, and mortise and tenon joints.
The additional versatility gained from use of this kit will turn your table saw into a remarkable
NOTE:
This router kit has been specifically designed for use with Ryobi Routers Only. The hole pattern on the mounting plate has not been drilled to accommodate other routers.
WARNING:
Attempting to assemble the Router Mounting kit or to use in any way without obtaining any missing parts and installing them correctly, could result in an accident resulting in possible serious injury.
WARNING:
Unplug the power supply cord of your saw from the electrical outlet before you begin mounting this kit. It should remain disconnected until the mounting operation is complete, all attachments are installed properly, and they have been checked to make sure they are secure. Failure to unplug your saw could result in accidental starting causing possible serious personal injury.
INFORMATION
Remove the loose parts from the box. Make sure that all items listed in the loose parts list and shown in Figure 1 on page 6 are included.
■Remove the loose parts from the box. Make sure that all items listed in the loose parts list are included.
■Inspect all parts carefully to make sure no breakage or damage occurred during shipping.
■If any parts are damaged or missing, please call
WARNING:
If any parts are missing do not assemble the kit until the missing parts are replaced. Failure to do so could result in serious personal injury.
TOOLS NEEDED
Tools needed for assembly of this kit are a phillips screwdriver, two flat head screwdrivers, and an adjustable wrench.
NOTE: The adjustable wrench will be used to tighten the threaded post into one of the special 5/16 in.
Page 5
