MAINTENANCE AND REPAIR INSTRUCTIONS
Outer Spool
Bottom
Eyelet Cover
Eyelet
Inner Reel
Fig. 17
14.Insert the ends of the line through the eyelets in the outer spool. Place inner reel inside the outer spool (Fig. 17).
15.While holding the inner reel and outer spool, grasp the ends of the lines and pull firmly. This will release the lines from the holding slots in the inner reel.
16.Press the bottom cover into the outer spool until it snaps into place.
INSTALLING A PREWOUND REEL
1.Press the tabs in and remove the bottom cover (Fig. 11).
2.Remove the old inner reel from the outer spool (Fig. 12).
3.Take the prewound inner reel and insert the ends of the line through the eyelets in the outer spool (Fig. 17).
4.While holding the inner reel and outer spool, grasp the ends of the lines and pull firmly to release the line from the holding slots in the inner reel.
5.Press the bottom cover into the outer spool until it snaps into place.
PAWL REPLACEMENT
If the pawl in the cutting attachment requires replacement due to cracking or wear, use the following instructions.
1.Position the pawl so that it is hooked by the spring (Fig. 18).
2.Slide a medium sized flat bladed screwdriver through the tab hole in the outer spool and under the pawl (Fig. 18). Position the end of the screwdriver next to the pawl shaft.
3.Turn the screwdriver to release the pawl from its retaining hole in the outer spool. Once it is loose, remove and discard the old pawl.
4.Replace with a new pawl. Press the pawl firmly over the pawl shaft until it snaps in place into its retaining hole.
Replacement Parts
Refer to the Accessories / Replacement Parts section.
Position Pawl | Pawl Shaft |
|
Tab Hole | Screwdriver |
| |
| Fig. 18 |
14