Ryobi CS30 RY30120 manual To Advance the Cutting Line Manually, Cutting Tips, See Figures 16

OPERATION

WARNING:

Always hold the string trimmer away from the body keep- ing clearance between the body and the product. Any contact with the housing or string trimmer cutting head can result in burns and/or other serious personal injury.

TO ADVANCE THE CUTTING LINE

String advance is controlled by tapping the string head on grass while running engine at full throttle.

Run engine at full throttle.

Tap the spool retainer on ground to advance string. The string advances each time the spool retainer is tapped. Do not hold the spool retainer on the ground.

NOTE: The line trimming cut-off blade on the grass deflector will cut the line to the correct length.

NOTE: If the string is worn too short you may not be able to advance the string by tapping it on the ground. If so, stop the engine, and manually advance the string.

TO ADVANCE THE CUTTING LINE MANUALLY

Push the spool retainer down while pulling on string(s) to manually advance the string.

CUTTING TIPS

See Figures 16 -17.

Avoid hot surfaces by always keeping the tool away from your body. (Proper operating position shown in figure 15.)

Keep the trimmer tilted toward the area being cut; this is the best cutting area.

The curved shaft trimmer cuts when passing the unit from right to left. The straight shaft trimmer cuts when passing the unit from left to right. This will avoid throwing debris at the operator. Avoid cutting in the dangerous area shown in illustration.

Use the tip of string to do the cutting; do not force string head into uncut grass.

Wire and picket fences cause extra string wear, even breakage. Stone and brick walls, curbs, and wood may wear string rapidly.

Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be damaged by the string.

GRASS DEFLECTOR LINE TRIMMING CUT-OFF BLADE

See Figure 18.

The trimmer is equipped with a line trimming cut-off blade on the grass deflector. For best cutting, advance string until it is trimmed to length by the cut-off blade. Advance the string whenever you hear the engine running faster than normal, or when trimming efficiency diminishes. This will maintain best performance and keep the string long enough to advance properly.

CURVED SHAFT TRIMMER

DANGEROUS

CUTTING AREADIRECTION OF ROTATION

BEST CUTTING
AREA	Fig. 16
STRAIGHT SHAFT TRIMMER

DANGEROUS

CUTTING AREA

DIRECTION OF	BEST CUTTING
	AREA
ROTATION	Fig. 17

STRAIGHT SHAFT

TRIMMER LINE TRIMMING

CUT-OFF BLADE

CURVED SHAFT TRIMMER

LINE TRIMMING CUT-OFF

BLADE

Fig. 18

16