15
ASSEMBLY
MOUNTING HOLES
The table saw must be mounted to a firm supporting surface
such as a workbench or leg stand (not included). Four bolt holes
have been provided in the saw’s base for this purpose. Each
of the four mounting holes should be bolted securely using
3/8 in. machine bolts, lock washers, and hex nuts (not
included). Bolts should be of sufficient length to accommo-
date the saw base, lock washers, hex nuts, and the thickness
of the workbench. Tighten all four bolts securely.
Carefully check the workbench after mounting to make sure
that no movement can occur during use. If any tipping, slid-
ing, or walking is noted, secure the workbench to the floor
before operating.
TO INSTALL THE BLADE ADJUSTINGHANDLE
See Figure 6.
The blade adjusting handle mounts to the height adjusting
handwheel with a shoulder bolt, washer, and lock nut.
n Insert the shoulder bolt in the center of the blade adjusting
handle. Place the washer over the bolt and insert into the
hole in the height adjusting handwheel.
n Place the lock nut behind the height adjusting handwheel,
and thread the lock nut onto the shoulder bolt.
n Holding the nut in place, tighten with a screwdriver.
UNPACKING
This product requires assembly.
n Carefully remove the tool and any accessories from the
box. Place it on a level work surface.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have
carefully inspected the tool, identified all loos e parts,
and satisfactorily operated the tool.
n If any parts are damaged or missing, please call 1-800-
525-2579 for assistance.
WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such altera-
tion or modification is misuse and could result in a hazard-
ous condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING:
Never stand directly in line with the blade or allow hands
to come closer than 3 in. to the blade. Do not reach over
or across the blade. Failure to heed this warning can
result in serious personal injury.
WARNING:
To avoid serious personal injury, always make sure the
table saw is securely mounted to a workbench or an
approved leg stand. NEVER operate the saw on the
floor.
Fig. 6
SHOULDER
BOLT
LOCK NUT
BLADE
ADJUSTING
HANDLE
HEIGHT
ADJUSTING
HANDWHEEL
WASHER