ASSEMBLY

INSTALLING THE POWER HEAD TO THE ATTACHMENT

See Figure 2.

WARNING:

Never install, remove, or adjust any attachment while power head is running. Failure to stop the engine can cause serious personal injury.

The attachment connects to the power head by means of a coupler device.

Loosen the knob on the coupler of the power head shaft

and remove the end cap from the attachment.

Push in the button located on the attachment shaft. Align

POWER HEAD

SHAFT

COUPLER

GUIDE

RECESS

BUTTON

POSITIONING

the button with the guide recess on the power head coupler

and slide the two shafts together. Rotate the attachment

HOLE

KNOB

shaft until the button locks into the positioning hole.

NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place.

Tighten the knob securely.

WARNING:

Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use to avoid serious personal injury.

REMOVING THE ATTACHMENT FROM THE POWER HEAD

For removing or changing the attachment:

Loosen the knob.

Push in the button and twist the shafts to remove and separate ends.

ATTACHING THE STORAGE HANGER

See Figure 3.

There are two ways to hang your attachment for storage.

To use the hanger cap, push in the button and place the hanger cap over end of the lower end attachment shaft. Slightly rotate the cap from side to side until the button locks into place.

The secondary hole in the attachment shaft can be used for hanging purposes as well.

TRIMMER ATTACHMENT

Fig. 2

HANGER

CAP

HOLE

SECONDARY

HOLE

BUTTON

Fig. 3

10

Page 10
Image 10
Ryobi SS30 RY30544 Installing the Power Head to the Attachment, Removing the Attachment from the Power Head, See Figure