OPERATION
DUST NOZZLE (MODEL CSB 130JS)
See Figure 22.
A dust nozzle is included with saw Model CSB130JS. As shown in figure 22, the dust nozzle fits over the dust chute which is located on the rear of the upper blade guard. Attach dust nozzle with a twisting motion. The easy rotation of the dust nozzle allows the operator to direct the flow of dust and chips. The dust and chip opening should always be turned away from the operator.
TO POCKET CUT
See Figure 23.
WARNING:
Always adjust bevel setting to zero before making a pocket cut. Attempting a pocket cut at any other setting can result in loss of control of your saw possibly causing serious injury.
Adjust the bevel setting to zero, set blade to correct blade depth setting, and swing the lower blade guard up using the lower blade guard handle. ALWAYS RAISE THE LOWER
BLADE GUARD WITH THE HANDLE TO AVOID SERIOUS INJURY. While holding lower blade guard by the handle, firmly rest the front of the base flat against the workpiece with the rear of the handle raised so the blade does not touch the work. See Figure 23. Depress the switch trigger.
ALWAYS LET THE BLADE REACH FULL SPEED, THEN SLOWLY LOWER BLADE INTO THE WORK UNTIL BASE IS FLAT AGAINST WORK. After you complete your cut, release the trigger and allow the blade to come to a complete stop. After the blade has stopped, remove it from the work. Then, corners may be cleared out with a hand saw or sabre saw.
WARNING:
Never tie the lower blade guard in a raised position. Leaving the blade exposed could lead to serious injury.
DUST | DUST |
CHUTE | NOZZLE |
UPPER |
|
BLADE GUARD |
|
MODEL CSB130JS | Fig. 22 |
LOWER BLADE |
|
GUARD |
|
45
0
| POCKET CUT |
LOWER BLADE |
|
GUARD HANDLE | Fig. 23 |
WARNING:
Do not use this product as a component of other products. Also, do not use attachments or accessories not recommended for use with this product. Any such use could result in possible serious personal injury.
Page 15
