Ryobi P200 manual TWO Speed Gear Train, Reversible

OPERATION

WARNING:

Battery tools are always in operating condition. There- fore, switch should always be locked when not in use or carrying at your side.

RELEASE (UNLOCK)

CHUCK COLLAR

KEYLESS CHUCK

See Figure 7.

A keyless chuck has been provided with your drill to allow for easy installation and removal of bits. As the name implies, you can hand tighten or release drill bits in the chuck jaws. Grasp and hold the collar of the chuck with one hand. Rotate the chuck body with your other hand. The arrows on the chuck indicate which direction to rotate the chuck body in order to GRIP (tighten) or RELEASE (unlock) the drill bit.

TWO SPEED GEAR TRAIN

See Figure 8.

GRIP

(TIGHTEN)

CHUCK

BODY

24

0 2

5

The drill has a two-speed gear train designed for drilling or driving at LO (1) or HI (2) speeds. A slide switch is located on top of your drill to select either LO (1) or HI (2) speed. When using drill in the LO (1) speed range, speed will decrease and unit will have more power and torque. When using drill in the HI (2) speed range, speed will increase and unit will have less power and torque. Use LO (1) speed for high power and torque applications and HI (2) speed for fast drilling or driving applications.

VARIABLE SPEED SWITCH

See Figure 9.

The drill starts and stops by depressing and releasing the switch trigger. The switch delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression. Release the switch trigger to turn drill OFF.

SWITCH LOCK

See Figure 9.

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direc- tion of rotation selector in the center position.

REVERSIBLE

See Figure 9.

This tool is reversible. The direction of rotation is controlled by a selector located above the switch trigger. With the drill held in normal operating position, the direction of rotation selector should be positioned to the left of the switch for drilling. The drilling direction is reversed when the selector is to the right of the switch. When the selector is in center position, the switch trigger is locked.

	Fig. 7
TWO SPEED	LO (1) SPEED
GEAR TRAIN
(HI-LO)

HI (2) SPEED 24

0

2

5

Fig. 8

DIRECTION OF	REVERSE
ROTATION
SELECTOR
	24
	0
	2

CENTER POSITION	SWITCH
(LOCK)	TRIGGER

Fig. 9

14