OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing.
NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to “CHARGING A COOL BATTERY PACK” for normal recharging of batter- ies. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check.
TO INSTALL BATTERY PACK
See Figure 4.
nLock the trigger switch by placing the rotation selector in the center position.
nPlace the battery pack on the tool.
nMake sure the latches on each side of the battery pack snap into place and the battery pack is secured on the tool before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installa- tion of the battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
See Figure 4.
nLock the trigger switch by placing the rotation selector in the center position.
nDepress the latches on the side of battery pack.
nRemove the battery pack from the tool.
SWITCH
See Figure 5.
nTo turn the drill ON, depress the switch trigger.
nTo turn the drill OFF, release the switch trigger.
BATTERY PACK
LATCHES
DEPRESS LATCHES TO |
|
RELEASE BATTERY PACK | Fig. 4 |
24
0 2
5
TO TURN ON
TO TURN OFF
Fig. 5
12