Whirlpool ETZOVK manual Install properly Remove sales labels, Level refrigerator-freezer, Clean it

Install properly...	Remove sales labels...
	Remove the Consumer Buy Guide label, tape
	and any lnslde labels before using the re-
	frigerator. To remove any remalnlng glue:
	1. Rub briskly with thumb to make a ball then
	remove.
	OR
	2. Soak area with liquid hand dishwashing
	detergent before removing glue as described
	in step 1.
	DO NOT USErubblng alcohol or flammable or
	toxic solvents, such as acetone, gasoline, car-
	bon tetmchlorlde, etc. These can damage the
	material.
	NOTE: DO NOT REMOVE ANY PERMANENT IN-
	STRUCTIONS LABELS INSIDE YOUR REFRIGER-
	ATOR.
	Do not remove the Tech sheet fastened under
	the refrlgemtor at the front.

1.Allow YZinch (1.25cm] space on each side and at the top of the refrigerator for ease of installation.

2.If the refrigerator is to be against a wall, you might want to leave extra space so the door can be opened wider.

3.The refrigerator back can be flush against the wall.

Level refrigerator-freezer...

All’ USE SCREWDRIVER

TO ADJUST

FRONT ROLLER

VELLING SCREW

1.Remove base grille (see page 7).

2.To raise front, turn screw in direction shown.

3.To lower front, turn screw in the direction shown,

4.Check with level.

Clean it...

Clean your refriger- 1 ator before using it.

See cleaning instruc- tions on page 8.

Plug- it in...

3-PRONG TYPE WA1

REFRIGERA;OR	3-PitONG
	GROUNDING PLUG
POWER CORD

RECOMMENDED GROUNDING METHOD

A 115Volt, 60 Hz.,AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate cir- cuit serving only this appliance be provided.

Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See individual electrical requirements and grounding instruction sheet in your literature package.

4