Whirlpool ET20VM, ETZOVK manual Changing the light bulbs, Removing the base grille, Ice cube trays

Changing the light bulbs...

3. Replace with a 40-watt appliance bulb.

Removing the base grille...	METAL CLIPS
To remove the grille:	rSUPPORT TABS

	.	-		SUPPORT TABS
				the grille:
1.	Open the doors.	To replace
		1. Line up grille support tabs with metal clips.
2.	Pull grille outwards as shown.
		2.	Push firmly to snap into place.
3.	Do not remove Tech sheet fastened behind
	orille	3.	Close the	doors.

Ice cube trays...

(Model ETPOGK)

If cubes are not used, they may shrink. The mov- ing cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

Automatic ice maker.. .

If you have Model ET20VM and have the auto- matic ice maker accessory, or if you have Model ET20VK and plan to add one later (Part No. ECKMF-831,there are a few things you will want to know:

lThe ON/OFF lever is a wire signal arm. Downfor making ice automatically Up...to shut off the ice maker.

l Shake the bin occasionally to keep cubes sepa- rated, and to obtain increased storage capacity.

lIt is normal for ice crescents to be attached by a corner. They will break apart easily

l You will hear water running when ice maker is working. You’ll hear ice fall into the bin. Don’t let these sounds bother you.

l

l

l

l

l

l

To remove Ice:

1.Hold tray at both ends.

2.Slightly twist.

The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.

Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice.

If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control to- ward a higher number. Wait a day and, if neces- sary, turn the Freezer Control toward A.

If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON position.

If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away They will be replaced. Cubes in the ice bin can also become smaller by evaporation.

Good water quality is important for good ice quality It is not recommended that the ice maker be connected to a softened water supply. Water softener chemicals such as salt from a malfunc- tioning softener can damage the ice maker mold and lead to poor quality ice. If a softened water supply cannot be avoided, then it is impor- tant that the water softener be well maintained and operating properly.

7