GE JCB968, JCB905 Using the surface units, How to Set, Using the Bridge Burner on some models

Using the surface units.

Be sure you turn the control knob to OFF when you finish cooking.

How to Set

Push the knob in and turn in either direction to the setting you want.

At both OFF and HI the control clicks into position. You may hear slight clicking sounds during cooking, indicating the control is keeping the power level you set.

A HOT SURFACE indicator light, on

the cooktop, will glow when any radiant element is turned on. It will remain on until the surface is cooled to approximately 150°F.

Hot surface indicator light will:

■come on when the unit is hot to the touch.

■stay on even after the unit is turned off.

■glow until the unit is cooled to approximately 150°F.

WARNING: The surface units are automatically disabled during the self-clean cycle. Make sure that all surface unit controls are turned off at all times during the self-clean cycle. Any surface unit that is set to an on position, while the self-clean cycle is operating, will automatically come on after the self-clean cycle is finished, and could result in an on, unattended surface unit. Wait until the self-clean cycle is finished to set and use the surface units.

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions

Using the Bridge Burner (on some models)

To use the bridge burner, turn the left front control knob to the BRIDGE BURNER settings.

For full bridge surface unit operation, also turn on the left rear surface unit.

To use only the front surface unit, turn the control knob to the FRONT BURNER settings.

Dual Surface Unit Control Knob (on some models)

The right front surface unit has 2 cooking sizes to select from so you can match the size of the unit to the size of the cookware you are using.

To use the small (6″) surface unit, turn the control knob to the SMALL BURNER settings.

To use the large (9″) surface unit, turn the control knob to the LARGE BURNER settings.

8