GE JCB968, JCB905 Installation Instructions INSTALL THE RANGE, Anti-Tipdevice Installation

Spirit level

Installation Instructions

INSTALL THE RANGE

2 ANTI-TIP DEVICE INSTALLATION

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include all necessary information to complete the installation. Read the Safety Instructions and the instructions that fit your situation before beginning installation.

Bracket Wall plate

Screw must enter wood or metal

Typical installation of anti-tip bracket attachment to wall

WARNING —

•Range must be secured by Anti-Tip bracket supplied.

•If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

•See instructions to install (supplied with bracket).

•Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury may result from spilled hot liquids or from the range itself.

4 LEVEL THE RANGE

AInstall the oven shelves in the oven and position the range where it will be installed.

BCheck for levelness by

placing a spirit level or a cup, partially filled with water, on one of

the oven shelves. If using a spirit level, take

two readings—with the

level placed diagonally first in one direction and then the other.

CThe front leveling legs can be adjusted from the bottom and the rear legs can be adjusted from the top or the bottom.

Lower

range

Leg leveler

Raise range

DUse an open-end or adjustable wrench to adjust the leveling legs until the range is level.

3 REMOVE STORAGE DRAWER

APull the drawer out until it stops.

BLift the front of the drawer until the stops clear the guide.

Stop

CRemove the drawer.

5REPLACE THE STORAGE DRAWER

APlace the drawer rail on the guides.

BPush the drawer in until it stops.

Stop

CLift the front of the drawer and push in until the stops clear the guides.

DLower the front of the drawer and push in until it closes.

38