Cisco Systems 3545 Serial, 3545 PRI Installing the Cisco Unified Videoconferencing 3545 Gateway

C H A P T E R 2

Installing the Cisco Unified

Videoconferencing 3545 Gateway

•Physical Description, page 2-1

•Requirements for Installation, page 2-3

•Verifying the Package Contents, page 2-4

•Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack, page 2-5

•How to Install the Gateway, page 2-6

•How to Perform the Initial Gateway Configuration, page 2-10

•Connecting the Gateway to the Network, page 2-15

•Connecting PRI Lines to the Gateway, page 2-15

•Connecting Serial Lines to the Gateway, page 2-15

•Serial Gateway Cable Connections and Pin-outs, page 2-16

•Connecting the Gateway to a Power Source, page 2-27

•Accessing the Gateway Administrator Interface, page 2-27

•Online Help Registration, page 2-28

Physical Description

•Gateway Module, page 2-1

•Cisco Unified Videoconferencing 3545 PRI Gateway RTM, page 2-2

•Cisco Unified Videoconferencing 3545 Serial Gateway RTM, page 2-3

Gateway Module

The gateway module has a 10/100BaseT Ethernet port on the front panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial port that you can use with a hyperterminal program to configure and monitor the module.

Figure 2-1shows the front panel components of the gateway module. Table 2-1describes these components.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.6

OL-17011-01 2-1