Cisco Systems 3545 Serial Related Topics, Serial Gateway Cable Connections and Pin-outs, page

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway

Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack

•V.35/RS366-DCE cable

•EIA449/RS366-DCE cable

•EIA530/RS366-DCE cable

Related Topics

•Serial Gateway Cable Connections and Pin-outs, page 2-16

Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack

You can optionally mount the Cisco Unified Videoconferencing 3545 chassis in a standard 19-inch rack. Two mounting brackets and a set of screws are included in the Cisco Unified

Videoconferencing 3545 chassis shipping box.

Procedure

Step 1 Disconnect all cables including the power cables.

Step 2 Place the Cisco Unified Videoconferencing 3545 chassis right-side up on a hard flat surface, with the front panel facing you.

Step 3 Position a mounting bracket over the mounting holes on each side of the Cisco Unified Videoconferencing 3545 chassis, as shown in Figure 2-4.

Step 4 Pass the screws through the brackets and tighten them into the screw holes on each side of the Cisco Unified Videoconferencing 3545 chassis using a suitable screwdriver.

Figure 2-4 Fitting a Bracket for Rack Mounting

157267

Step 5 Insert the Cisco Unified Videoconferencing 3545 chassis into the 19-inch rack.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.6

OL-17011-01 2-5