Cisco Systems 3545 PRI, 3545 Serial Installing the Gateway Module, Before You Begin, Procedure

Models: 3545 Serial 3545 PRI

1 76
Download 76 pages 29.66 Kb
Page 28
Image 28
Installing the Gateway Module

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway

How to Install the Gateway

Caution Do not force the connection. Forcing the connection can bend or damage the pins in the connector inside the chassis.

Step 8 Snap the handles forward to secure the RTM module in the slot.

Step 9 Secure the RTM module screws.

Caution Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place.

Installing the Gateway Module

This section describes how to install the Cisco Unified Videoconferencing 3545 Gateway module in the Cisco Unified Videoconferencing 3545 chassis.

Before You Begin

Warning You must install the RTM module before you install the gateway module. Inserting an RTM module in the rear of the chassis when a gateway module is already installed in the same position at the front of the chassis may damage the chassis.

Procedure

Step 1 On the front of the chassis, loosen the screws of the blank panel covering the slot into which the gateway module is to be installed.

Step 2 Remove the blank panel.

Step 3 Remove the new gateway module from the antistatic bag.

Step 4 Press the red buttons and open the handles of the gateway module.

Step 5 Align the edges of the gateway module with the chassis guide rails.

Step 6 Slide the gateway module into the chassis until it stops (see Figure 2-5for the Cisco Unified Videoconferencing 3545 chassis).

Step 7 Use even pressure to push the module further into the slot.

Caution Do not force the connection. Forcing the connection can bend or damage the pins in the connector inside the chassis.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.6

2-8

OL-17011-01

 

 

Page 28
Image 28
Cisco Systems 3545 PRI, 3545 Serial manual Installing the Gateway Module, Before You Begin, Procedure