OPERATION

APPLICATIONS

You may use this product for the following purposes:

Limbing and pruning branches from trees

Felling small trees up to 7 in. diameter

Bucking the fallen tree into shorter lengths

This product will accept Ryobi One+ 18 V lithium- ion battery packs and Ryobi One+ 18 V nickel- cadmium battery packs.

For complete charging instructions, refer to the Operator’s Manual for your Ryobi One+ battery pack and charger models.

TO INSTALL / REMOVE BATTERY PACK

See Figure 5.

WARNING:

Always remove battery pack from your tool when you are assembling parts, making adjust- ments, cleaning, carrying, transporting or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury.

NOTE: To avoid serious personal injury, always remove the battery pack and keep hands clear of the look-out button when carrying or transporting the tool.

To install:

Place the battery pack in your chain saw. Align raised rib on battery pack with groove in chain saw’s battery port.

Make sure the latches on each side of the bat- tery pack snap in place and that battery pack is secured in chain saw before beginning operation.

To remove:

Locate latches on side of battery pack and depress both sides to release the battery pack from the chain saw.

CAUTION:

CAUTION:

Remove battery pack from unit. Fill oil tank with Ryobi Bar and Chain Lubricant before starting the chain saw. Failure to lubricate the chain will cause damage to the bar and chain.

CHAIN OIL SYSTEM

See Figure 6.

Use Ryobi Bar and Chain Lubricant. It is formu- lated to perform over a wide temperature range with no dilution required.

NOTE:Donotusedirty,usedorotherwisecontam- inated oils. Damage may occur to the bar or chain.

Carefully pour the bar and chain oil into the tank.

Check and fill the oil tank when battery is recharged, or as needed.

Depress the oil tank cap several times to pump the oil to the chain before starting the saw.

Depress the oil tank cap every 20-30 seconds while cutting to keep the chain lubricated.

NOTE: It is normal for lubricant to seep from the saw when not in use. To prevent seepage, empty the oil tank after each use. When storing the unit for a long period of time (three months or longer) be sure the chain is lightly lubricated; this will prevent rust on the chain and bar sprocket.

BATTERY

 

PORT

BATTERY

 

PACK

LATCHES

Fig. 5

When placing battery pack in your chain saw, be sure raised rib on battery pack aligns with groove in chain saw’s battery port and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.

Fig. 6

11 - English

Page 11
Image 11
Ryobi P545 manuel dutilisation Applications, To Install / Remove Battery Pack, Chain OIL System