OPERATION
PROPER CUTTING STANCE
See Figure 11.
Weight should be balanced with both feet on solid ground.
Keep left arm with elbow locked in a “straight arm” position to withstand any kickback force.
Your body should always be to the left of the chain line.
Thumb should be on underside of handlebar.
BASIC CUTTING PROCEDURE
Practice cutting a few small logs using the following technique to get the “feel” of using the saw before you begin a major sawing operation.
Take the proper stance in front of the wood with the saw off.
Squeeze the switch trigger and let the chain accelerate to full speed before entering the cut.
Begin cutting with the saw against the log.
Keep the unit running the entire time you are cutting, maintain a steady speed.
Allow the chain to cut for you; exert only light downward pressure. If you force the cut, dam- age to the bar, chain, or unit can result.
Release the switch trigger as soon as the cut is completed, allowing the chain to stop. If you run the saw without a cutting load, unnecessary wear can occur to the chain, bar, and unit.
Do not put pressure on the saw at the end of cut.
WORK AREA PRECAUTIONS
Cut only wood or materials made from wood, no sheet metal, no plastics, no masonry, no
Never allow children to operate the saw. Allow no person to use this chain saw who has not read this Operator’s Manual or received ade- quate instructions for the safe and proper use of this chain saw.
When felling a tree, keep everyone - helpers, bystanders, children, and animals - a safe distance from the cutting area. During felling operations, the safe distance should be a least twice the height of the largest trees in the fell- ing area. During bucking operations, keep a minimum distance of 15 feet between work- ers.Trees should not be felled in a manner that
CHAIN LINE
STRAIGHT ARM POSITION
Fig. 11
would endanger any person, strike any utility line or cause any property damage. If the tree does make contact with any utility line, the utility company should be notified immediately.
Always cut with both feet on solid ground to prevent being pulled off balance.
Do not cut above chest height, as a saw held high- er is difficult to control against kickback forces.
Do not fell trees near electrical wires or build- ings. Leave this operation for professionals.
Cut only when visibility and light are adequate for you to see clearly.
TREE FELLING
See Figures 12 - 15.
Unusual Hazardous Tree Felling Conditions
Do not fell trees during periods of high wind or heavy precipitation. Wait to do your cutting until the hazard has ended.
WARNING:
Do not cut down trees having an extreme lean or trees that have rotten limbs, loose bark, or hol- low trunks. Have these trees pushed or dragged down with heavy equipment, then cut them up.
DANGER:
Electrocution hazard. Do not cut trees or branches near power lines or electrical wires. Contact with power lines or live electrical wires will result in serious personal injury or possible death.
14 - English
