Ryobi P710 manual Adding Attachments, General Maintenance

OPERATION

ADDING ATTACHMENTS

See Figures 6 - 8.

The brush attachment, crevice tool and squeegee attach- ment can be easily snapped into place on your hand vac.

nTurn off the vacuum.

nInsert the attachment to the front end of the vacuum dust bowl, making sure the attachment is firmly snapped into place.

TO INSTALL

TO REMOVE

BRUSH

ATTACHMENT

Fig. 6

TO INSTALL

TO REMOVE

CREVICE TOOL

Fig. 7

TO INSTALL

	TO REMOVE
SQUEEGEE
ATTACHMENT	Fig. 8

MAINTENANCE

WARNING:

When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.

WARNING:

To avoid serious personal injury, always remove the battery pack from the tool when cleaning or performing any maintenance.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.

Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at a Ryobi Authorized Service Center.

13