SPECIFIC SAFETY RULES
nDo not use to pick up hard objects such as nails, screws, coins, etc. Damage or injury could result.
nHand vac does not have to be plugged into an electrical outlet, therefore it is always in operating condition. Be aware of possible hazards when using the hand vac or when changing accessories.
nRemove battery when the vacuum is not in use and before servicing.
nUse only the charger recommended for your hand vac. Do not substitute any other charger. Use of another charger could cause batteries to explode causing pos- sible serious injury.
nDo not place hand vac or batteries near fire or heat. They may explode.
nThe hand vac should be charged in a location where the temperature is more than 50°F but less than 100°F.
nUnder extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact with skin, wash at least 10 minutes then seek immediate medical attention.
nBatteries vent hydrogen gas and can explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal in jury, never use any cordless product in the presence of an open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately.
nKnow your power tool. Read operator’s manual care- fully. Learn its applications and limitations, as well as the specific potential hazards related to this tool. Following this rule will reduce the risk of electric shock, fire, or serious injury.
nTo reduce the risk of electric shock, use the vacuum indoors only.
nAlways wear safety glasses. Everyday eyeglasses have only
nProtect your lungs. Wear a face or dust mask if the operation is dusty. Following this rule will reduce the risk of serious personal injury.
nElectric shock could occur if charged outdoors or on wet surfaces.
nCheck damaged parts. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center. Following this rule will reduce the risk of shock, fire, or serious injury.
nSave these instructions. Refer to them frequently and use them to instruct others who may use this tool. If you loan someone this tool, loan them these instruc- tions also.
4
